Publicité
Les langues disponibles
Les langues disponibles
VI. Teaching the detectors
Remove the bottom from the top of the housing of the radio controlled display module before starting teaching.
To do that, unscrew the screws on the bottom and pull off the housing section.
Connect the power supply and plug in the jack on the radio controlled display module.
1. General key functions:
• SELECT key
• SET key
• ESC key
2. DIP switch functions:
• DIP 1
• DIP 2
Both are factory activated (recommended setting).
3. Main menu structure in the radio controlled display module:
• Submenu LED 01:
• Submenu LED 02:
• Submenu LED 03:
• Submenu LED 16:
Navigation through the menus:
• Select the main menu from the display mode: Press SELECT key 1 once
• The submenu LED 01 (teach detector) can be opened with SET key 2
• Selecting the other submenus: With SELECT key 1, jump to the desired submenu;
corresponding LED is shining green
• Open the desired submenu with SET key 2
Hint: If you have opened an incorrect submenu by mistake, you can exit it using the ESC key.
You can always return to the display mode by pressing the ESC key several times.
(Ta1):
Selects menus / values / zones
(Ta2):
Confirms the selection, partially with a delay of 4 seconds (keep pressed)
(Ta3):
Abort, go back one step
Supervision – Monitoring on/off (see Point VI. Remarks)
Malfunction – Monitoring on/off
Teach detector
Delete detector
Wireless level indicator, detector
Delete all (factory reset)
DIP switch
Key
11
Publicité
