Zanussi ZCG054G Notice D'utilisation page 23

Flexible nonmetal pipes connection
If it is possible to easily control the connection in its full
area, you can use a flexible pipe. The flexible pipe must
be tightly attached by clamps.
Installation: use the rubber pipe holder. Always engage
the gasket. Then continue with the gas connection. The
flexible pipe is prepared for apply when:
– it can not get hot more than room temperature, higher
than 30°C;
– it is no longer than 1500 mm;
– it shows no throttles;
– it is not subject to traction or torsion;
– it does not get in touch with cutting edges or corners;
– it can be easily examined in order to check its condi-
tion.
The control of preservation of the flexible pipe consists
in checking that:
– it does not show cracks, cuts, marks of burnings on
the two ends and on its full length;
– the material is not hardened, but shows its correct
elasticity;
– the fastening clamps are not rusted;
– expired term is not due.
If one or more defects are visible, do not repair the pipe,
but replace it.
Important! When installation is complete, make sure that
the seal of each pipe fitting is correct. Use a soapy
solution, not a flame!
The gas supply ramp is on the rear side of the control
panel.
Warning! Before gas connection disconnect the
mains plug from the mains socket or switch off the
fuse in the fuse box. Close the primary valve of the gas
supply.
1
1 Gas connection point (only one point is applicable
for appliance)
2 Gasket
3 Adjustable connection
4 LPG rubber pipe holder
The appliance is set to default gas, to change the
setting choose pipe holder No 4. Always use the
gasket sealing
Injectors replacement
1. Remove the pan supports.
2. Remove the caps and crowns of the burner.
3. With a socket spanner 7 remove the injectors and
replace them with the ones which are necessary for
the type of gas you use.
4. Assemble the parts, follow the same procedure back-
wards.
5. Replace the rating label (it is near the gas supply pipe)
with the one for the new type of gas supply. You can
find this label in the package of the injectors supplied
with the appliance.
If the supply gas pressure is changeable or different from
the necessary pressure, you must fit an applicable pres-
sure adjuster on the gas supply pipe.
Adjustment to different types of gas
Warning! Let only an authorized person do the
adjustment to different types of gas.
This appliance is for operation with natural gas.
With the correct injectors, you can also operate it
with liquid gas.
The gas rate is adjusted to suit.
2 3 2 4
23