HBM C16A Série Instructions De Montage page 11

Wägezelle Load cell
•
SUNSTAR传感与控制 http://www.sensor-ic.com/ TEL:0755-83376549 FAX:0755-83376182 E-MAIL:szss20@163.com
Contents
1 Safety instructions
2 Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3 Connection
4 Technical data
5 Dimensions
1 Safety instructions
The load cells can be used as machine components. Please note that in these cases, in order to
achieve high sensitivity, the load cells have not been designed with the safety factors normally
applied in machine design.
Where a fracture might involve damage to property and injuries to persons, appropriate safety
measures (e.g. support against collapse) must be taken by the user (observe the relevant accident
protection regulations).
Take into account the maximum limit loads given in the technical data. The technical data for the
load cells applies within the specified load limits only.
The electronic system processing the measurement signal must be designed such that no
consequential damage is caused by the failure of the measurement signal.
--Position of rotation stop dowel pin:
-- Grease load introduction parts and dowel pins:
-- Align load cells vertically
-- Adjust lateral stops of weighing platform:
SUNSTAR自动化 http://www.sensor-ic.com/ TEL: 0755-83376489 FAX:0755-83376182 E-MAIL:szss20@163.com
Capteur de pesage
•
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
or
C16A/...
radially position open side
11
Page
11
12
15
16
28