Bosch GLM 150 Professional Notice Originale page 16

Masquer les pouces Voir aussi pour GLM 150 Professional:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OBJ_BUCH-1044-001.book Page 16 Tuesday, October 13, 2009 9:49 AM
16 | English
Examples:
a) Positive difference:
24.3 ft = (12 x 2.0 ft) + 0.3 ft
The mark-out value 2,0 ft is
contained 12 times in a total
distance of 24,3 ft. Addition-
ally, the total distance con-
tains a rest of 0,3 ft. Reduce
the distance between the
measuring tool and the start-
ing point by 0,3 ft difference,
and then mark off the length.
b) Negative difference:
23.7 ft = (12 x 2.0 ft) – 0.3 ft
For a total distance of 23,7 ft,
0,3 ft are missing for the
mark-out value 2,0 ft to be
contained 12 times. Increase
the distance between the
measuring tool and the start-
ing point by 0,3 ft difference,
and then mark off the length.
Briefly pressing measuring button 7 ends the
mark-out mode. Pressing and holding the meas-
uring button 7 restarts the mark-out mode anew
(with the same mark-out value).
The mark-out mode automatically switches off
after 5 min. For prior exiting of the function,
press one of the measuring-mode buttons.
List of the last Measuring Values
The measuring tool stores the last 30 measuring
values and their calculations, and displays them
in reverse order (last measured value first).
To recall the stored measure-
ments, press button 15. The
result of the last measure-
ment is indicated on the dis-
play, along with the indicator
for the measured-value list d
as well as a counter for the
numbering of the displayed
measurements.
1 609 929 T68 | (13.10.09)
When no further measurements are stored after
pressing button 15 again, the measuring tool
switches back to the last measuring function. To
exit the measured-value list, press one of the
measuring-mode buttons.
To delete the currently displayed measured-val-
ue list entry, briefly press button 16. To delete
the complete measured-value list, press and
hold the button for the measured-value list 15
and at the same time briefly press button 16.
Deleting Measured Values
Briefly pressing button 16 deletes the last indi-
vidual measuring value determined in all meas-
uring functions. Briefly pressing the button re-
peatedly deletes the individual measured values
in reverse order.
In wall surface measurement mode, briefly
pressing button 16 the first time deletes the last
individually measured value; pressing the button
a second time deletes all lengths B
ing the button a third time deletes all room
heights A.
Adding Measured Values
To add measured values, firstly carry out any
measurement or select an entry from the meas-
ured-value list. Then press the plus button 6. For
confirmation, "+" appears on the display. Then
carry out a second measurement or select an-
other entry from the measured-value list.
To call up the sum of both
measurements, press the re-
sult button 5. The calculation
is indicated in the measured-
value lines a, and the sum in
the result line c.
After calculation of the sum, further measured
values or measured-value list entries can be add-
ed to this result when pressing the plus button
6 prior to each measurement. Pressing the re-
sult button 5 ends the addition.
, and press-
X
Bosch Power Tools

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Glm 250 vf professional

Table des Matières