Philips sonicare HealthyWhite Mode D'emploi page 11

White mode brushing instructions
The Clean and White mode consists of 2 minutes of Clean mode to
clean the whole mouth and an additional 30 seconds of White mode
to focus on the visible front teeth.
1 Brush the first 2 minutes as explained in section 'Brushing
instructions'.
2 After the 2 minutes of Clean mode, the White mode starts with a
change in brushing sound and motion. This is your signal to start
brushing the upper front teeth for 15 seconds.
3 At the next beep and pause, move to the bottom front teeth for
the final 15 seconds of brushing (Fig. 9).
Brushing modes
Philips Sonicare automatically starts in the default Clean mode.
To select a different brushing mode:
1 Press the on/off button to toggle between modes.
The green LED indicates the selected mode.
Note: You can only switch between modes when the toothbrush is
switched on.
-
Clean mode: Standard mode for superior teeth cleaning.
-
Sensitive mode (specific types only): Gentle yet thorough cleaning
for sensitive gums and teeth.
-
Clean and White mode: 2 minutes of Clean mode with an
additional 30 seconds of White mode to focus on the visible front
teeth.
Note: When the Sonicare is used in clinical studies, the default
2-minute Clean mode must be selected. However, in whitening/
stain reduction studies, the Clean and White mode must be selected.
The handle should be fully charged and the Easy-start feature
deactivated.
11
English