MT Logic TWINTALKER 9310 Manuel D'utilisateur page 6

Twintalker 9310
8 Getting started
8.1 Installing/Removing the Belt Clip
1. To remove the belt clip from the unit, push the
belt clip (B) towards the antenna, while pulling
the clip tab (A).
2. When re-installing the belt clip, a click
indicates the belt clip is locked into position.
8.2 Battery Installation
1. Remove the belt clip (See chapter "8.1 Installing/Removing the Belt Clip").
2. Open the locking latch (C) and slide off the battery cover.
3. Install the rechargeable battery pack following the polarity as shown. Ensure that the
metal contacts on the side (D) are facing outwards so they will make contact to the
battery door.
4. Close the battery door.
5. Re-install the belt clip.
6
A
B
C
D
Twintalker 9310