MT Logic TWINTALKER 9310 Manuel D'utilisateur page 13

Once there is a transmission on the channel, the CTCSS code (if used) will be detected and
displayed.
•
•
(section 12.10.3)
12.10.3 Scanning for a DCS code
Once there is a transmission on the channel, the DCS code (if used) will be detected and
displayed.
If you press the PTT button while listening to a found DCS code, the PMR
will go back in stand-by mode on the channel with the DCS code.
12.11 Call Tones
A call tone alerts others that you want to start talking.
12.11.1 Setting the Call Tone
The Twintalker 9310 has 10 call tones.
Twintalker 9310
• Press the
flashes on the display for the selected radio channel.
• Press the
scan.
If you press the PTT button while listening to a found CTCSS
code, the PMR will go back in stand-by mode on the channel with
the CTCSS code.
If no CTCSS code is detected there is a chance that DCS is
selected by the user. In this case you can scan for the DCS code.
• Press the
flashes on the display for the selected radio channel.
• Press the
• Press the
the current call tone is flashing.
• Press the
Call Tone.
• Press the PTT - button to confirm and return to stand-by
mode.
-button six times: "SC" and "CTCSS 00"
-button or the -button to start the CTCSS
-button seven times: "SC" and "DCS 00"
-button or the -button to start the DCS scan.
- button eight times, "CA" is displayed and
- button or the - button to change to another
Twintalker 9310
13