MT Logic TWINTALKER 9310 Manuel D'utilisateur page 14

Twintalker 9310
12.11.2 Sending a call Tone
Press the button briefly. The call tone will be transmitted on the set channel.
12.12 Roger Beep On/Off
After the -button is released, the unit will send out a roger beep to confirm that you have
PTT
stopped talking.
To set the Roger Beep.
• Press the
• Press
• Press the PTT - button to confirm your selection and return to the
standby mode.
12.13 Key-Tone On/Off
When a button is pressed, the unit will beep briefly.
To set the key-tone.
• Press
• Press
• Press the PTT - button to confirm your selection and return to the.
12.14 Dual Channel Monitor function
In stand-by, the PMR is set on one channel with CTCSS/DCS code. The PMR will only
receive signals transmitted on that channel with the CTCSS/DCS code.
Dual Channel Monitor (DCM) allows you to monitor a second channel with CTCSS/DCS
code.
When the Dual Channel Monitor function is activated, the PMR will switch sequentially
between the standby channel + CTCSS/DCS code and the Dual Channel + CTCSS/DCS
code.
14
- button nine times. 'rO' will be displayed.
to enable (ON) or
ten times. 'tO' will be displayed.
to enable (ON) or
standby mode.
• Press the
the display.
• Press the
channel.
• Press the
go to CTCSS selection. (Press the
DCS selection)
• Press the
code or DCS code.
• Press the PTT-button to confirm and return to stand-by
mode.
• To disable the function select "OF" when selecting the DCM
channel.
to disable the Roger-Beep (OF).
disable the Key Tones (OF).
-button eleven times," DCM OF" will flash on
-button or the -button to change the
-button to confirm the channel selection and
-button or the -button to change the CTCSS
-button again to go to
Twintalker 9310