Temperature Regulation / Internal Parts / Hints - Kuppersbusch IKU 159-0 Instructions D'emploi

Temperature regulation
The temperature is automatically regulated and can
be increased to achieve a higher temperature
(warmer) by rotating the thermostat knob toward
lower settings or reduced (colder) rotating the knob
towards higher settings.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
refrigerator depends on:
• room temperature;
• how often the door is opened;
• the quantity of food stored;
• location of appliance.
A medium setting is generally the most suitable.
Important
If the ambient temperature is high or the
appliance is fully loaded, and the appliance is
set to the lowest temperatures, it may run
continuously causing frost to form on the rear
wall. In this case the dial must be set to a higher
temperature to allow automatic defrosting and
therefore reduced energy consumption.
Internal Parts
Storage shelves
• The shelves can be removed for cleaning.
• To permit storage of food packages of various
sizes, the shelves can be placed at different
heights.
• To remove the internal shelf pull forward until it can
be tipped up or down and removed.
Please do the same in reverse to insert the shelf at
a different height.
• For better use of space, the front half-shelves can
lie over the rear ones.
The glass shelf above the vegetable drawers
and the bottle shelf should always remain in
position, to ensure correct air circulation.
• To permit storage of food packages of various
sizes, the central door shelf can be adjusted in
height.
• Gradually pull the shelf in the direction of the
arrows until it comes free, then reposition as
required.
• For more thorough cleaning, the top and bottom
door sheves can be removed by pulling them in the
direction of the arrows, then refitting them in
position.
Hints
•
Saving Energy
• Pay careful attention to where the cabinet is
placed. See the section "Installation". When
installed correctly the cabinet will consume less
energy.
• Try to avoid keeping the doors open for long
periods or opening the doors too frequently as
warm air will enter the cabinet and cause the
compressor to switch on unnecessarily often.
• If the ambient temperature is high, the thermostat
knob is on the coldest setting (higher numbers) and
D338
CP1OEM
17