Getting Started - Ribimex Ribitech PRLPV120 Manuel D'instructions

IV. GETTING STARTED
Before any intervention on product, ensure that switch is on the "OFF" position
4.1- Unpacking
Remove product from its packaging.
Check that tool and accessories are not damage.
4.2- Charging the battery
Note: The battery is supplied partially charged. To ensure proper running of the tool, completely charge
the battery in the provided charger before first time use.
4.2.1- Inserting and removing the battery
a) To insert the battery: slide the battery into the handle's compartment.
Make sure that the battery is securely locked.
b) To remove the battery: press the release button (6) and pull battery out of its compartment.
4.2.2- Charging the battery
- Place charger on a flat and dry surface within 1m of a wall socket.
- Remove battery from tool.
- Insert jack into charging port directly on battery.
- Plug in battery charger to wall socket (power source)
(Only use with provided adaptor)
- Charge during 1 hour or 3/5 hours (based on model).
- After charging, remove jack from charging port and insert battery on tool.
Then disconnect charger from mains and store it adequately.
Note: Maintain the charger and the battery at a temperature between +10°C and +40°C.
4.3- Inserting and removing a bit
Open chuck electrically.
Insert the selected drill/driver bit into the chuck. Make sure that it is centered.
Rotate the chuck until the drill/driver is gripped.
Using even torque tighten the chuck.
4.4- Switch On/Off (Fig.1)
To operate product, press on trigger switch (7).
To stop product, release the trigger switch (7).
Note: the switch cannot be activated wen the selector (8) is set in middle position.
4.5- Changing to Forward or Reverse mode (Fig.1)
To change the rotation, press on the Forward/Reverse selector (8).
Note: do not abruptly change rotating direction when machine is operating.
4.6- Torque setting (Fig.1)
To adjust the torque, rotate the selector (2) to desired level.
4.7- Speed selector (Fig.1) – Only on PRLPV144
Place the speed selector (3) on desired position:
- Low (low speed with high torque)
- High (high speed with low torque)
Remark: Ensure that product has come to a stop before proceeding to any adjustment.
Page 21 / 38