Noise Level - Ribimex Ribitech PRLPV120 Manuel D'instructions

Keep hands well away from the underside of the workpiece during use. Do not use your hands to
remove any dust, chips or other waste while the tool is in use. Do not touch the bit right after
operation, as it may be hot and cause burns.
9. When using tool for screwing/unscrewing, place the screw bit on the screw head only when power
tool is switched off.
10. Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The
following hazards may arise in connection with the tool's construction and design:
a. Damage to lungs if an effective dust mask is not worn.
b. Damage to hearing if effective hearing protection is not worn.
c. Health defects resulting from vibration emission if the power tool is being used over longer period of
time or not adequately managed and properly maintained.
d. Health hazard resulting from dusts from materials containing harmful substances.
Wear hearing protection while operating the power tool.

10.1. Noise level

Wear ear protection
The measured values have been measured in accordance with a standard test method.
The measured values are mentioned in the characteristics table.
10.2. Vibrations level
The declared vibration total value has been measured in accordance with a standard test method and may
be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
Warning! The vibration emission during actual use of the power tool can differ from the declared total
value depending on the ways in which the tool is used.
There is the need to identify safety measures to protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times
when the tool is switched off and when it is running idle in addition to the trigger time).
10.3- Electromagnetic field
Warning! This machine produces an electromagnetic field during operation. This field may under some
circumstances interfere with active or passive medical implants. To reduce the risk of serious or fatal
injury, we recommend persons with medical implants to consult their physician and the medical implant
manufacturer before operating this machine.
11. Electrical Safety
Always check that the voltage of the power supply matches the voltage indicated on the tool's rating plate.
12. If the power cable is damaged, it must be replaced by the manufacturer, its after sales service or a
person with similar qualification in order to avoid any danger.
If the power cable or extension cord is damaged or cut during operation, immediately disconnect plug
from its main power source. Do not touch the cable or extension cord before unplugging from main
power.
13. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially for
any matters that are not referred in the above
14. Warning
The use of any accessory or attachment, other than those recommended in this instruction manual,
may present a risk of injury to persons or animals and may cause damages.
15. Have your tool repaired by a qualified person
Repairs should only be carried out by qualified persons using original spare parts, otherwise it may
result in considerable danger to the user.
Page 19 / 38