Getting Started - Ribimex Ribitech PRBAT20/VCSB Manuel D'instructions Et D'utilisation

The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially for
any matters that are not referred in the above
12. Warning
The use of any accessory or attachment, other than those recommended in this instruction manual,
may present a risk of injury to persons or animals and may cause damages.
13. Have your tool repaired by a qualified person
Repairs should only be carried out by qualified persons using original spare parts, otherwise it may
result in considerable danger to the user.
ATTENTION! The machine's operation generates a certain level of noise. National or local regulations
regarding noise nuisance may restrict the use of the machine to certain hours. Check with your local
authority.
IV. GETTING STARTED
Before any intervention on product, ensure that switch is set on the "OFF" position,
remove the battery and unplug the charger from its power source.
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage.
4.2- Assembly
The tool does not require assembly prior to first time use.
4.3- Battery & Charger
NOTE: The battery and the charger are NOT supplied.
The recommended battery and charger for the tool are listed in table 3 and 2 respectively.
Note: always completely charge a battery in its recommended charger before first time use.
LEDs on battery
The LEDs on the battery (b) indicate the charging level of the battery.
Press on button [a], the LEDs battery level will light up:
3 LEDs on = the battery is fully charged (full capacity).
2 LEDs on = the battery is half charged (medium capacity).
1 LED on = the battery capacity is low and needs to be charged.
0 LED on = the battery is depleted.
Inserting and removing the battery (tool)
a) To insert the battery on tool: slide the battery into its compartment (6)
on the handle bottom part.
Make sure that the battery is securely locked.
b) To remove the battery: press the release button (c) and pull battery
out of the compartment (6).
Page 20 / 38