Getting Started - Ribimex PRTOURBAT37 Manuel D'instructions Et D'utilisation

IV. GETTING STARTED
4.1- Unpacking
• Remove the product from packaging.
• Check if the product and accessories (if any) are intact.
4.2- Content
• 1 screwdriver
• 1 set of 12 screwdriver bits
• 1 micro-USB charging cable
• 1 instruction manual
4.3- Assembly
No assembly or adjustment is required by the user.
4.4- Charging the battery
• The built-in battery is a lithium-ion battery that can be charged
anytime without affecting battery life.
• Charge the battery before the first use.
• Connect the provided charging cable to the micro-USB port (6)
on the tool. (Fig. 2)
• Connect the other end of the charging cable to a suitable USB 2,0
power adaptor (5V
socket.
• Red indicator (7) light illuminates when charging is in progress.
• NOTE: Do not charge the battery from USB ports of computer.
4.5- Installing / removing bit
• NOTE: Do not use double end bit.
• The chuck (2) accepts 6,35 mm hex accessories only.
• Pull the chuck collar outward, then align and insert the bit into the chuck.
• Release the chuck collar to lock the bit in place. It is normal that the bit can be moved back
and forth slightly.
• To remove the bit, pull the chuck collar outward, then remove the bit and release the collar.
4.6- Forward / reverse operations
• For clockwise rotation, press and hold the forward operation button (5).
• For anti-clockwise rotation, press and hold the reverse operation button (3).
• The spindle will be automatically locked if none of the buttons was pressed, the tool is
capable for manual screwdriving.
4.7- LED worklight
• The LED worklight (4) will be automatically started if any operation button was pressed.
1,0A), then plug the adaptor to the wall
Fig. 2
Page 10 / 18