Stalgast 9730100 Notice D'instruction page 22

The power cord should be flexible, oil-resistant, earthed, polychloroprene-coated - it can be made by the
manufacturer and available from him or in specialist repair shops!
•
Only an authorized technician with a certificate for electrical works may connect the device to the
electrical grid.
•
The appliance should be connected to a 400V 50Hz three-phase socket equipped with a circuit breaker
In=30mA by means of a plug or directly to the power supply.
To connect the device to an electrical equalizing system:
•
loosen the nut on the screw
•
enter the equipotential conductor
•
tighten the nut all the way
•
connect the other end of the equipotential cord to the equalizer.
Figure 10. Connecting the unit to an electrical equalizing system.
CAUTION!! During the first use of the device the process of „burning-in" should be performed in
accordance with the below items:
•
install the device according to the above instruction
•
set all control knobs to the maximum temperature
•
wait around 30 minutes
After the above process is completed, you can proceed with normal operation with the device. During
the first use of a new hob unpleasant odors are released, which result from the natural „burning-in" of the
heaters. These smells will disappear after the first use.
5. INSTALLATION - LID
This lid is designed and manufactured as a subassembly for mounting to grill hobs 9731100,
9731200 and 9731300 made by Stalgast Radom Sp. z o.o. Do not attempt to install it to other
products or use it for any purpose other than the expansion of these grill sets.
This manual describes the assembly of the lid on the grill hob 9731100. Installation in the case of
hobs 9731200 and 9731300 is analogous.
CAUTION! Assembly should be carried out by at least two people! Assembly by one person can
lead to injury and damage to the grill hob and lid.
After unpacking, check whether the unit has any visible damage. If the lid was damaged during transport
it should not be installed!
•
Before installing, please remove the protective film from the device. Wash the external surfaces with
a cloth soaked in warm water and a degreasing agent, and then dry. Do not use agents which could
scratch the surface.
PE – protective wire (yellow-green)
N – neutral wire (blue)
L1, L2, L3 – phase wires (other colors)
Figure 9. Connecting the unit to the mains.
- 22 -