Télécharger Imprimer la page

Stalgast 9730100 Notice D'instruction page 19

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
Thank you for purchasing our product. Please carefully read this instruction manual before first use.
Reproduction of this manual without the consent of the manufacturer is prohibited.
The photos and drawings are for illustrative purposes only and may differ from the purchased device.
CAUTION: The manual should be kept in a safe place, available to the staff. The manufacturer reserves
the right to change the technical parameters of the device without prior notice.
1.
SAFETY INSTRUCTIONS
Caution! If the device was damaged during transport it should not be connected!
Incorrect operation and improper use may result in serious damage to the device or injuries to persons.
The device should only be used for the purpose for which it was designed.
The manufacturer assumes no liability for any damages caused by incorrect operation and improper use
of the device.
During operation the device and the power cable plug must be protected against contact with water
or other liquids. If the device accidentally fell into water or was flooded with water, it is necessary to
immediately pull out the plug from the socket, and then commission the inspection of the device to an
expert technician.
Failure to follow this instruction may cause life-threatening situations.
Never open the housing of the device on your own.
Do not insert any objects into the openings in the housing of the device.
Do not touch the power cord plug with wet hands.
Regularly inspect the condition of the plug and the power cord. In the event any damage to the plug or
the cable is found, it should be repaired in an authorized repair point.
In case the device falls or is damaged in any other way, before further use it is always necessary for it to
be inspected and possibly repaired at a specialized repair point.
Never attempt to repair the device on your own - it could lead to life-threatening situations.
It is prohibited for any changes and repairs to be performed by unauthorized persons.
Protect the power supply cable from contact with sharp or hot objects and keep it away from open
flames. If you want to disconnect the device from the electrical socket, always grab it by the plug and
never pull by the power cable.
Secure the power cable to ensure that no one pulls it from the socket by mistake and that no one trips
over the cable.
Control the operation of the device during use.
Do not allow for the device to be used by minors, people with physical or mental disabilities and people
with impaired mobility, as well as persons without the appropriate experience and knowledge regarding
the proper use of the device. Such persons can operate the device only under the supervision of a
person responsible for safety.
If the device is not currently in use or is cleaned, it is necessary to always unplug it from the power
source by removing the plug from the socket.
CAUTION: If the plug of the power cord is connected to the electrical socket, the device
remains energized.
Switch the device off before pulling the plug from the power socket.
The device must be well visible and easily accessible after the installation.
It is necessary to provide easy access to the socket of a non-detachable power cable.
2.
OCCUPATIONAL HEALTH & SAFETY RULES
In order to prevent burns and electric shock please observe the following safety rules:
Personnel using the appliance must be trained in the safe operation in accordance with the information
in this manual as well as the basic principles of use of electrical and workplace safety equipment. In
the aforementioned areas, pre-training (before the employee's first use of the machine) and periodic
training must be carried out for personnel.
Do not leave the turned on device unattended. Unplug the device from the power supply when it is not
used and prior to maintenance.
It is prohibited to turn the device on, if any heating element and/or control element is damaged. Before
starting, make sure that the unit is in working condition and that it is prepared to operate in accordance
with this manual.
Make sure that the power cord does not touch the hot surfaces of the machine and that it is not expo-
sed to cuts.
There should be no flammable items near the device.
During operation, the unit heats up - it is important to be aware of the possibility of burns on contact
- 19 -

Publicité

loading