Installation And Operation; Safety Instructions; Installation And Connection - Bartscher Compact Cool 700.080 Mode D'emploi

5. Installation and operation

5.1 Safety instructions

WARNING! Electrical hazard!
The device must only be connected to a properly installed single socket with
protective contact.
Never yank cord to disconnect from outlet.
Cable must not touch any hot parts.
•
See that the cable does not touch any heat sources or sharp edges. Do not let the
cable dangle over the counter edge.
•
Do not use the device in case it does not function properly, has been damaged or
dropped.
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
•
Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance! Take note of the security advice!

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of the
device.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
•
Do not place the device in the vicinity of open sources of fire, electric cookers,
furnaces or other sources of heat such as e.g., in places exposed to direct sunlight.
The heat can damage the surface of the device, as well as have a negative effect on
the cooling power and increase the consumption of energy.
•
To avoid damage to the compressor, do not tilt the device to an angle greater than 45°
during setup or transport. Be careful when touching the condenser and doors, as
damage to them will negatively impact the working of the device.
- 25 -