Presetting Radio Stations - Sony RXD-700 Mode D'emploi

Presetting Radio Stations

This section shows you how to store up to 30 of your
favourite FM or AM stations manually onto preset
codes made up of characters (A, B or C) and numbers
(1–0), such as A7. You can store up to 10 stations on
each of the 3 different letters. You can use these letters
to classify stations according to music category or
station band.
PRESET +/–
ENTER MEMORY
1
Press POWER to turn on the CD Receiver.
2
Press TUNER FM/AM repeatedly to choose either
FM or AM.
3
Press and hold PRESET +/– and release it when
the frequency numbers start changing.
Press PRESET + for a higher frequency; press
PRESET – for a lower frequency.
When this unit locates a station, "TUNED"
appears in the display and scanning stops
automatically (Automatic Tuning).
If "PRESET" appears in the display
Press TUNE MODE repeatedly until "PRESET"
disappears from the display, then do the above
procedure.
4
Press MEMORY.
The lowest available preset code number flashes to
indicate that this unit is ready to store the station.
5
Press PRESET +/– repeatedly until the preset code
you want appears in the display.
Each time you press the button, the preset code
changes as follows:
" A1 " " ... " " A0 "
" C0 " " ... "
If you store a station at a preset code where you
have already stored another station, the previous
station is erased.
6
Press ENTER.
This unit stores the station at the preset code you
specified.
TUNER FM/AM
TUNE MODE
" B1 " " ... "
" C1 " " B0 "
7
Repeat Steps 2 through 6 to store other stations.
When you tune in AM stations
Adjust the direction of the AM loop aerial for optimum
reception.
If the STEREO indicator remains off
Press ST/MONO when an FM stereo broadcast is
received.
If an FM stereo programme is distorted
The STEREO indicator flashes. Press ST/MONO to
change to monaural (MONO). You will not have the
stereo effect but the distortion will be reduced. To return
to stereo mode, press this button again.
If you cannot tune in the station you want (Manual
Tuning)
With Manual Tuning, you can search through all stations
broadcasting on each band, and tune in stations with
extremely weak signals that you might not be able to
receive with Automatic Tuning.
1 Press TUNER FM/AM repeatedly to choose FM or
AM.
2 Press PRESET +/– repeatedly until you tune in the
desired station.
Press PRESET + for a higher frequency; press
PRESET – for a lower frequency.
If "PRESET" appears in the display
Press TUNE MODE repeatedly until "PRESET"
disappears from the display, then do the above
procedure.
RDS (Radio Data System) Station names are stored
automatically
When you preset an RDS station broadcasting station
name information, the station name is automatically
stored at the station preset.
If you want to label the stations
Follow the procedure described in "Naming the Preset
Stations" on page 13.
Note
If the mains lead is disconnected for about a month, the preset
stations will be cleared from the CD Receiver's memory, and
you will have to preset the stations again.
Getting Started
EN
7