Advanced Tuner Operations; Using The Display; Naming The Preset Stations - Sony RXD-700 Mode D'emploi

Advanced Tuner Operations

Using the Display

If you assign a name to each preset station, you can
check information about the radio stations. See
"Naming the Preset Stations" on page 13 to assign a
name.
Each time you press the DISPLAY button, the display
changes as shown below.
Frequency
F M 1 O O . O M H 5
Press DISPLAY.
Station name
F M B B C R
Press DISPLAY.
DISPLAY
z A 2
1 A 2
Advanced Tuner Operations Advanced Tuner Operations Advanced Tuner Operations Advanced CD Operations

Naming the Preset Stations

You can assign a name up to 8 characters to each preset
station except FM RDS stations.
TIMER +/–
ENTER
1
Press CHAR.
The cursor flashes in the display.
2
Press TIMER +/– to select a character.
3
When the character you want appears, press
CHAR to move the cursor to the position for the
next character.
If you make a mistake
Press CHAR repeatedly until the character you want to
change flashes. (Each time you press the CHAR button,
the next character flashes.) Press TIMER +/– to select a
new character.
4
Repeat Steps 2 and 3 until the station name you
want appears in the display.
5
Press ENTER.
The lowest available preset code number flashes to
indicate that this unit is ready to store the station.
6
Press TIMER +/– to select the preset code where
you want to store the station name.
7
Press ENTER.
This unit stores the station at the preset code you
specified.
You can check the frequency of the displayed station
name
Press DISPLAY.
CHAR
EN
13