Wurth Master WAS 80 Notice D'utilisation page 9

0703 261 0.book Seite 9 Donnerstag, 29. Mai 2008 3:28 15
Take into account environmental influences.
Provide for good lighting. Keep your working
zone tidy. Protect the hose from bends, contrac-
tions, heat and sharp edges. Ensure a secure
stand.
Repetitive work movements, unfavourable posi-
tions and vibrations can damage your hands
and arms. Interrupt your work if you feel
numbness or pain in your arms/hands, if you
feel tingly or if your skin turns pale. Consult a
doctor if the problems continue to persist.
Tool Specifications
Compressed-air excentric grinder
N° of article
Course
Spindle thread
Idle-running speed
Grinding disc
Water connection
Water pressure (max.)
Performance
Air consumption
Max. operating pressure
Air connection
Weight
Machine Elements
1 Compressed-air excentric grinder
2 Compressed-air lubricator*
3 Pressure reducer
4 Filtre/water separator
5 Non-return valve
6 Pressure reducing valve
7 Compressed-air line
8 Compressor
9 Handle bar
10 Water valve
11 Compressed-air valve
12 Water hose
13 Sanding plate
14 Spanner flat
Not all of the accessories illustrated or described are included
as standard delivery.
*The compressed-air tool can, as far as the conditions are ful-
filled, be used without oil.
For Your Safety
Never lay a tool down unless the working at-
tachment has stopped moving.
This compressed-air tool may not be operated
in rooms with danger of explosion.
This compressed-air tool is not insulated
against the contact with electric sources.
Keep tools and accessories that are not used at
a dry place which is not accessible for children.
Use only original Würth parts and accesso-
ries.
This machine is intended for wet sanding.
WAS 80
For damage caused by usage other then intended,
0703 261 0
the user is responsible.
2.5 mm
M14
-1
Compressed-air connection
5 000 min
80/100/125 mm
Provide the tool with clean, dry air. A higher pres-
10 mm
sure (max. 6.3 bar) reduces the lifetime of the tool
6 bar
considerably.
435 W
The compressed-air tool has been designed to be
113 l/min
used without oil, assuming a clean, dry air supp-
6.3 bar
ly. Prior to use, add some drops of oil into the air
1/4"
admission of the compressed-air tool. As an alter-
native, use a compressed-air lubricator in the air
1.3 kg
conduction which is set at two drops per minute
max.
Pressure that is too low reduces the performance
of the pneumatic tool; pressure that is too high is
not allowed.
Connect the water hose 12 to the machine. Con-
nect the water hose to a water cock or a suitable
water pressure-tank.
When using a water pressure-tank, pay attention
that the water pressure is sufficient while working
(2 bar).
The max. water pressure may not exceed
6 bar. When the water pressure is higher, use
a pressure reducer!
Intended Use
Water Connection
9