Safety Notes - Scheppach GP1000 Jet LCD Traduction Des Instructions D'origine

5. Safety notes

• This device is not designed to be op-
erated by persons (including children)
with impaired physical, sensory or men-
tal capabilities, or who have insufficient
experience and/or insufficient knowl-
edge unless they are being supervised
by a person who is responsible for their
safety or they are receiving instruction
about how this device is to be used.
Children should not be left unattended,
to ensure they do not play with the de-
vice.
• Keep packaging films out of the reach
of babies and children. Risk of suffoca-
tion!
• The user is responsible for third parties
in the working area of the device.
• Prior to commissioning, it must be en-
sured by means of expert testing that
the required electrical protective meas-
ures are in place.
• m Warning! The pump may only be
used in and around stagnant water, gar-
den and swimming ponds with a resid-
ual current circuit breaker with a rated
residual triggering current of up to 30
mA (per VDE 0100 parts 702 and 738).
• The pump is not suitable for use in
swimming pools, paddling pools of any
kind and other waters where persons or
animals may be present during opera-
tion.
• Operating the pump while humans or
animals are in the danger zone is not
permitted. Ask your electrician!
• Always carry out a visual inspection of
the unit before use. Do not use the unit
if safety devices are damaged or worn
out. Never disable safety devices.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
• Only use the device for the purpose
specified in these original operating in-
structions.
• You are responsible for safety in the
work area.
• If the connection cable of this unit is
damaged, it must be replaced by the
manufacturer or their service depart-
ment or a similar qualified person in or-
der to avoid hazards. The voltage of
230 volts AC indicated on the type plate
of the pump must correspond to the
mains voltage present.
• Never lift, transport or fasten the pump
by the mains cable.
• Make sure that the electrical plug con-
nections are located in a flood-proof ar-
ea or are protected against moisture.
• Before any work on the pump, pull out
the mains plug.
• Ensure that the pump is not exposed to
a direct water jet.
• The operator is responsible for compli-
ance with local safety and installation
regulations (ask a qualified electrician if
necessary).
• The user must implement suitable
measures (e.g. installation of an alarm
system, reserve pump or similar) to pre-
vent consequential damage caused by
flooding of rooms in the event of pump
faults.
• If the pump fails, repair work may only
be carried out by a qualified electrician
or by customer service.
• Only use original spare parts.
• The pump must never be allowed to run
dry or be operated with a fully closed
suction line. Damage to the pump
caused by dry running will invalidate
the manufacturer's warranty.
GB | 23