Dantherm CDP 40 Manuel D'entretien page 5

Electrical heating coil for CDP dehumidifier
Terminal Rail Assembly Procedure
1. Use flat screwdriver
to remove terminal
rail blocks.
3. The terminal rail
block can also be
clipped on.
4. Place bridge in the
three blue terminal
rail blocks.
6. Glass fuse in large
terminal rail block.
10A 5x20mm
2. Slide additional
terminal rail blocks
into place in this
order.
5. Press bridge firmly
into place.
6. Activate heater
as described in
operation chapter,
section "Code ºC"
in the dehumidifier
manual.
EN
5