HQ Power VDP1500LFM Notice D'emploi page 5

When all devices have the same address, all the units will "listen" to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you set
different addresses, each device will "listen" to a separate channel number. Changing the settings of one
channel will only affect the device in question.
In the case of the 1-channel VDP1500LFM, you will have to set the start address of the first unit to 1, the
second unit to 2 (1 + 1), the third to 3 (2 + 1), and so on.
b. Remote Control
1. Up
2. Cursor left / right
3. Display
4. Down
5. TIME button
6. OUTPUT button
7. LOCK button
Plug the remote control into the rear of the smoke machine. Once the smoke machine is connected to the
mains and switched on, the main switch will light indicating the unit is receiving power. The bar beneath the
HEAT indication on the remote control display will blink. After a warm-up time of ± 5 minutes, the blinking bar
will switch to OK, indicating the unit is ready.
Use to move through the various features. Adjust the settings with
produce the fog.
MU Minutes. Time between two bursts.
SE Seconds. Time between two bursts.
Volume of fog output in 10% increments. To create a steady output, adjust the volume
VO
and press .
DE Duration of one smoke burst.
Timer function. This function allows you to set the operation time of the smoke machine.
OUTPUT Press to start or to stop the fog production.
Lock. Used to produce a steady output.
c. Preparing the Ice Box
Remove the screw on the top cover. Open the box and add ice cubes into the reservoir. Drain the reservoir
using the pump on the front. The reservoir can also be drained electronically during operation.
6. Cleaning and Maintenance
1. All screws should be tightened and free of corrosion.
2. The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension, trussing)
should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not
change the location of the connections.
3. Moving mechanic parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts.
8. Contact your dealer for spare parts if necessary.
VDP1500LFM
5
or and press OUTPUT to
HQPOWER