Foppapedretti Babyguard Mode D'emploi page 29

2C. Installation of the Babyguard on the car seat without built-in belt with
straps and harness
• Insert the strap with hoops into the loop on the underneath of the monitoring
device (fig. 1).
• Install the Babyguard on the car seat (as shown in Figure 2) fitting the hoop
on the right end of the strap on the right armrest and the hoop of the left end
of the strap on the left armrest, as shown in the figure 3. Make sure that it is
installed correctly.
INSTALLATION
FIG. 1
FIG. 2
• ENGLISH •
29
FIG. 3