Foppapedretti Babyguard Mode D'emploi page 28

2B. Installation of the Babyguard on the car carrycot
• Insert the strap with velcro into the loop on the underneath of the monitoring
device (fig. 1).
• Place the Babyguard on the upper side of the carrycot mattress (fig. 2).
• Thread the ends of the velcro straps through the slots on the mattress (as
shown in the figure 3). Run the straps along the underneath of the mattress and
attach the velcro to secure them.
• Place the mattress inside the carrycot (fig. 4), and follow the kit instructions
in the "CAR APPROVED SET" code 9700372100 (sold separately) for the
information regarding assembly of the car installation kit.
FIG. 1
FIG. 4
• ENGLISH •
INSTALLATION
FIG. 2
28
FIG. 3
velcro