emerio CME-121523.1 Mode D'emploi page 7

screen. If you want to reset this when the appliance has started running or has been set automatic start,
you have to first cancel the the appliance's running or automatic start, then change the mode for aroma
intensity.
7. Start brewing coffee by pressing the ON/OFF switch once. The red indicator light
The lid of the jug needs to be closed in order to unlock the drip stop function.
8. If you leave the device switched on, the tray will keep the coffee warm after finishing brewing. The whole
working process will last 35 minutes. After 35 minutes the unit will be automatically shut off and stop
working. You can manually press the ON/OFF switch again to switch on the appliance.
Note: The appliance is designed with an Anti-drip function. You can temporarily remove the jug and pour out
coffee during brewing cycle without coffee dripping from the appliance within 30 seconds.
CAUTION! When pouring coffee from the jug, pour it slowly. Do not incline the jug suddenly in a large tilting
angle, in case the hot coffee flows out from the lid rim and hurt people. Do not put an empty jug back on the
hot warming tray.
AUTOMATIC START FUNCTION
If you do not want the coffee maker to start operation immediately, for example now it is 5:10 pm, you hope
that the coffee maker will automatically start at 8:15 in the evening, first follow steps 1 to 6 of above section,
and then you can set the automatic start function as follows:
1. Press PROG button one time, the word "CLOCK" is showed at the up-right corner of
display.
2. Press the HOUR and MIN button continuously to set the current time (real clock), that is
17:10 (see Fig. 1).
Note: the time cycle is 24 hours.
3. Press PROG button again and the word TIMER shows on up-left corner of display.
4. Set the delayed starting time by pressing HOUR and MIN button repetitively, that is 20:15
(see Fig. 2).
5. Press the "ON/OFF" button twice, the blue indicator light
current clock. You may see the automatic start time by pressing PROG twice.
Note:

You may cancel the automatic start function by pressing "ON/OFF" button once to stop machine, or
pressing "ON/OFF" button twice to start brewing immediately.

You can reset the present time and automatic start time by pressing the PROG button once or twice.
Remember when there is a "CLOCK" displayed, you can modify the current time, and when "TIMER" is
displayed, you can modify the automatic start time. If there is no word marking on top, the display shows
the set current time.

If you need to change the time setting midway, you have to press "ON/OFF" button first to exit from the
automatic start function first and then reset the time.

When the time is due, the indicator light changes from the blue one to the red one and the unit starts
brewing. When brewing is finished, the coffee maker will be automatically shut off after 35 minutes if it is
not manually switched off.
Descaling:

Regularly descale the coffee maker. The intervals of descaling depend on the water hardness and frequency
of operation. In case of average water hardness we suggest descaling every 3 or 4 months. Please use a
commercially available decalcification agent.

Fill 400 ml of water into the reservoir and add the necessary amount of decalcification agent in accordance
with the dosing instructions.
will illuminate. The LED display will show the
- 6 -
will illuminate then.