What If There Are Problems - Medel Quick Mode D'emploi

of the cuff with a soft cloth after moistening it
with Ethyl alcohol (75-90%), then dry the cuff by
airing.
• Under no circumstances hold the device and cuff
under water, as this can cause liquid to enter and
damage the device and cuff.
• If you store the device and cuff, do not place heavy
objects on the device and cuff. Remove the batteries.
• Do not remove cuff from monitor. It is recom-
mended to clean the cuff after the usage of every
200 times.

9. What if there are problems?

Error Possible cause
message
The systolic or
or
diastolic pressure
could not be
measured.
Solution
Please wait one
minute and repeat the
measurement.
Ensure that you do not
speak or move during
the measurement.
Error Possible cause
message
The systolic or
or
diastolic pressure
is outside of the
measurement
range.
The cuff was
or
not attached
correctly.
50
Solution
Please wait one
minute and repeat the
measurement.
Ensure that you do not
speak or move during
the measurement.
If the message is
displayed again, you
should seek medical
assistance and check
the accuracy of your
procedure.
Please observe the
information in the
chapter on "Attaching
the cuff".