Cleaning And Maintenance - Medel Quick Mode D'emploi

• Press the memory button M.
AM AM flashes on the display.
The average value of the morning
measurements for the last 7 days is
displayed (morning: 5 a.m. – 9 a.m.).
• Press the memory button M.
PM PM flashes on the display.
The average value of the evening
measurements for the last 7 days is
displayed (evening: 6 p.m. – 8 p.m.).
• When you press the memory but-
ton M again, the last individual
measurement is displayed (in this
example, measurement 03).
• When you press the memory button M again, you
can view your individual measured values.
• To switch the device off again, press the START/
STOP button .
You can exit the menu at any time by pressing
the START/STOP button .
49
• To clear the relevant user memory, you must first
select a user memory.
• Start the retrieval of the average measured values.
A flashes on the display and the average value of
all saved measured values in this user memory is
displayed.
• Press and hold the memory button M and the
START/STOP button
ing on the user memory you are in.
All values of the current user memory
are deleted and the device switches
off.

8. Cleaning and maintenance

• It is recommended the performance should be
checked every 2 years or after repair. Please contact
the service center.
• Clean the device and cuff carefully using a slightly
damp cloth only.
• Do not use any cleaning agents or solvents.
• It is recommended the cuff should be disinfected
2 times every week if needed (e.g. in hospital).
Wipe the inner side (the side with contact to skin)
for 5 seconds, depend-