LaserLiner PowerBright-Laser PBL P5 Mode D'emploi page 12

Les langues disponibles

PowerBright-Laser PBL 5P

Optional: Working with the laser receiver RX

For levelling over longer distances or in conditions

of bright light, use the laser receiver RX. Switch on

with button D; control lamp A will light up.

IMPORTANT: Set the PBL 5P to hand receiver

mode (button 13). The laser lines will now pulsate

with high frequency (10 kHz), making the laser

lines darker. The laser receiver can detect these

pulsating laser lines up to a maximum distance of

50 m.

Now move the receiver field (F) of the laser

receiver through the laser lines upwards and

downwards (horizontal laser line) and/or sideways

(vertical laser line) until the centre LED (G) lights

up. Now mark the horizontal and/or vertical

reference dimension.

Adjust the sensitivity of the laser receiver with but-

ton B. Green LED (C) for close-range working up

to max. 15 m, red LED (C) for distance-range

working up to max. 50 m. The sound can be

switched on or off with button E.

Note:

The light intensity of the laser lines is highest in the middle and lessens

towards the edges. The maximum range of the laser receiver therefore also

changes accordingly: Green LED max. 7 – 15 m, red LED max. 30 – 50 m.

Optional: Universal mount

The laser receiver RX can be fitted on measuring

staffs with the universal mount. The Flexi measu-

ring staff (Art. No. 080.50) is always recommen-

ded when measuring from floor heights. It also

allows you to determine heights directly without

any need for calculation.

ENGLISH