Vertical Installation (Pdp-614Mx Only); Attaching The Bracket(S) And Display Fittings To The Plasma Display; Attaching The Wall Mounting Unit To The Wall - Pioneer PDK-WM03 Mode D'emploi

Vertical Installation
CAUTION
Models PDP-615PRO, PRO-1410HD, and PDP-615EX do not support vertical installation.

1. Attaching the Bracket(s) and Display Fittings to the Plasma Display

There are two display fittings, one for the right side, the other for the left. Mount the fittings so that their eye bolts are at the
inner side. Attach the fittings so that when viewed from the rear of the plasma display, the eye bolts are positioned at the
right side. Attaching the fittings in the opposite orientation will cause damage to the plasma display.
φ9
Bracket
ブラケット

2. Attaching the Wall Mounting Unit to the Wall

Screw the wall mounting unit to the wall using commercially
available anchors or the 6 M8 screws.
Mount with the upper hook holes at the top.
Upper hook holes
NOTE: Make sure that the anchors or screws are
fastened into sections of the wall at which there
are beams. (Use anchors or screws that are suited
for use on the type of wall on which the unit is
being mounted.) For details, see the following
Table of Wall Material vs. Anchors and Screws.
(PDP-614MX only)
φ9
For the Left
アイボルト Eye bolt
For the Right
Lower hook holes
■ Table of Wall Material vs. Anchors and Screws
Wall Material
Gypsum board
Plywood
Concrete
Block
ALC
Mortar
Brick
Wooden posts
* The extraction strength should be 500 kg or greater per position.
E-6
1 Use 2 of the included M8 screws to fasten one of the
two brackets to the plasma display in the direction
shown on the diagram.
2 Line up the screw holes (ø9, indicated on the dia-
gram) in the display fittings (one each for left and
right sides) with the screw holes (M8) in the rear panel
of the plasma display, and fasten the display fittings
using 2 of the included M8 screws for each fitting.
Reference: (PDP-614MX only)
When using the PDK-TS06 optional stand, the
display fittings can be attached with the plasma
display mounted on the stand.
When lifting the display, do not allow the stand to be
lifted together with the display. If the stand were to
come off, it could cause injury or damage.
591
950
Center for 61" types
400
494.5
Anchor
* Do not mount on plaster or plywood boards.
Be sure to fasten into a beam.
All anchors (850) or bolt plugs (300)
Tie-Lock anchors (No. 25)
Coach screws (ø8 x 50)
610