Hendi 272602 Mode D'emploi page 6

Patio heater assembly
Assembly instructions
• Screwdriver / Adjustable Spanners / Wrenches
• Leak Detection Solution one part detergent and
three parts water
• Before assembly, make sure all protection packing
material must be moved.
• Assembling all nuts and bolts loosely at first.
Tighten all connections after completion of as-
sembly. This eases your work and increase the
stability of your appliance.
• Small deviations in equipment may occur. This is
no lack of quality but subject to improvements.
SETP 1: Screw rear panel of housing to the base with
5pcs bolts M5 x 12 and 5pcs washer. (Detail
Abb. A)
SETP 2: Push the housing lid over rear panel of
housing and place onto rear panel of hous-
ing. Screw together the housing lid and rear
panel of housing with 5pcs bolts M5x12 and
5pcs washers. (Detail Abb. B)
EN
SETP 3: Fix the post assembly upwards onto the
housing lid with 4pcs bolts M5 x 12 and 4pcs
washers, then put plastic cover through the
post. (Detail Abb. D-1)Connect the post as-
sembly with 3pcs M5x12 screw and 3pcs flat
washer. (Detail Abb. D-2)
SETP 4: Fix one piece reflector to the central dome
with 1pc bolt M6*8, 1pcs cap screw, 1pcs
flat washer firstly. (Detail Abb. E-1).Connect
the second reflector part to the first one and
central dome with 3pc bolt M6x8, 3pcs cap
screw, 3pcs flat washer later. (Detail Abb.
E-2). Fix the third reflector part with 5pc
bolt M6x8, 5pcs cap screw, 5pcs flat washer
at last.. (Detail Abb. E-3)
SETP 5: Tighten inner gas pipe to main burner (See
Figure 1), Then fix main burner to the post
with 3 bolts M5x12 and 3pcs washers. (De-
tail Abb. F)
NOTE: DO NOT OVER TIGHTEN! REFER TO
LEAK TESTING ON PAGE 5.
6
SETP 6: Fix the door to housing. (See Figure 2 and
Detail Abb. F)