GUTFELS KA8102swi Mode D'emploi page 20

grind the necessary amount of coffee beans and then it will brew the coffee. The LCD
display will show
When the coffee stops flowing, you will hear 3 beeps and

display, the keep warm indicator lamp will start flashing and the appliance goes to the
keep warm mode for 35 minutes before it switches off automatically.
When you remove the jug from the appliance, a non-drip valve will automatically operate

to stop any drops of coffee dripping onto the hotplate. Replacement of the carafe
automatically opens the non-drip valve and allows remaining coffee to filter through into
the jug.
Wait until the brewing process is finished and the filter has run empty before removing the

jug.
PREPARATION OF COFFEE WITH COFFEE POWDER
Open the lid of the water tank.

Pour the desired amount of water into the water tank. Make sure not to overfill by using

the glass jug only to pour the water.
Attention: never fill the water tank with more water than for the number of cups you want,
because your appliance will only stop when the water tank is empty.
Remove the glass jug from the hotplate. Press the release button of the filter holder (OPEN).

Swing the filter holder, insert a paper filter or permanent filter (depending on the model) in
the filter holder and add the desired quantity of ground coffee (1 teaspoon per cup,
approximately 6g). Please note: fold the bottom and the side edges of the paper filter in
such a way that it fits perfectly in the filter holder. Replace the filter holder, making sure it is
placed correctly. Always put the filter holder back into place before putting the jug on the
hotplate, otherwise the anti-drip system will disturb you when doing so.
Never forget to close the lid of the jug before putting the jug on the hotplate.

Never forget to close the lid of the water tank before switching on your coffee maker.

Choose the number of cups you desire with the selector for the number of cups (2, 4, 6, 8,

10 or 12).
Press the GRIND OFF button once. Check that your appliance is in the "coffee powder"

mode and not in the "coffee mill" mode. To do so, check that the indicator lamp of the
coffee powder mode selector switch (GRIND OFF button) is lit.
Switch on the coffee maker with the ON/OFF switch. The pilot light of the switch will be

illuminated, indicating that your appliance works. The LCD display will show
the brewing process begins.
When the coffee stops flowing, you will hear 3 beeps and

display, the keep warm indicator lamp will start flashing and the appliance goes to the
keep warm mode for 35 minutes before it switches off automatically.
When you remove the jug from the appliance, a non-drip valve will automatically operate

to stop any drops of coffee dripping onto the hotplate. Replacement of the carafe
automatically opens the non-drip valve and allows remaining coffee to filter through into
the jug.
Wait until the brewing process is finished and the filter has run empty before removing the

jug.
PROGRAMMING THE COFFEE MAKER
You can programme your coffee maker to brew fresh coffee at a preset time, both in the

coffee powder mode and in the coffee mill mode.
To do so, proceed as follows:

Make sure the coffee maker's clock is set to the right time.

when the brewing process begins.
20
will disappear from the
when
will disappear from the