GUTFELS KA8102swi Mode D'emploi page 19

Once all the water has passed through, switch the appliance off and let it cool down. When it
is cold enough, repeat the process with fresh water. Repeat this process 3 times.
Your appliance can only be used/programmed when the LCD display is illuminated.
If the display is not illuminated, press any key to illuminate the display and start using/
programming the appliance.
Caution: during use, hot steam may escape from the steam vent, stay away from this steam
vent in order not to get burnt and never cover this steam vent.
SETTING THE CLOCK
Plug in your coffee maker. The LCD display will light up to indicate that you can set the

clock.
Then press the HOUR button to set the hours, and the MIN button to change the minutes.

By each impulse on one of those buttons, the hour or minutes will increase by 1 unit but if

you keep the pressure, the time will roll forward more quickly.
When the clock is set, you can use your appliance.

Later on you can adapt the time at any moment simply by pressing the HOUR and MIN

buttons when the LCD display is lit.
Your appliance can be used with coffee beans or coffee powder.
The regular setting is for a use with coffee beans, but after each use your appliance will keep
your last choice in its memory. If you unplug the appliance, the memory will be erased and the
appliance will be on the regular setting again.
PREPARATION OF COFFEE WITH COFFEE BEANS
Open the lid of the water tank.

Pour the desired amount of water into the water tank. Make sure not to overfill by using

the glass jug only to pour the water.
Attention: never fill the water tank with more water than for the number of cups you want,
because your appliance will only stop when the water tank is empty.
Close the lid of the water tank.

Fill the coffee bean compartment completely with coffee beans and put the lid of the

compartment correctly back in place.
Choose the type of grinding you desire with the grinding fineness selector (from "fine" to

"coarse").
Check that your appliance is in the "coffee mill" mode and not in the "coffee powder"

mode. To do so, check that the indicator lamp of the coffee powder mode selector
switch (GRIND OFF button) is not lit.
Choose the number of cups you desire with the selector for the number of cups (2, 4, 6, 8,

10 or 12).
Choose the type of coffee you desire with the aroma selector switch STRENGTH CONTROL

(Light = MILD / Middle = MEDIUM / Strong = STRONG).
Remove the glass jug from the hotplate. Press the release button of the filter holder (OPEN).

Swing the filter holder, insert a paper filter or permanent filter (depending on the model) in
the filter holder. Please note: fold the bottom and the side edges of the paper filter in such
a way that it fits perfectly in the filter holder. Replace the filter holder, making sure it is
placed correctly. Always put the filter holder back into place before putting the jug on the
hotplate, otherwise the anti-drip system will disturb you when doing so.
Never forget to close the lid of the jug before putting the jug on the hotplate.

Switch on the coffee maker with the ON/OFF switch. The pilot light of the switch will be

illuminated, indicating that your appliance works. After 3 seconds, your appliance will first
19