Omnitronic CM-860 Mode D'emploi page 18

• The CM-860 features one separately controllable microphone channel (DJ MIC). This microphone can be
connected via the XLR/1/4" jack-mounting socket on the front panel accepting ¼" jack plugs and XLR-plugs.
With the Talkover-button, you can attenuate the level of all other signal-sources without affecting the
microphone volume.
Occupation balanced XLR-connection:
Input
Occupation jack plug:
Unbalanced use of
mono 1/4" jack plugs
Tip =
Signal (+)
Sleeve =
Ground / Shield
Tip
Sleeve
Strain relief clamp
• Additionally, the CM-860 features one more ¼" Mic 1 jack plug on the rear panel. You can adjust the
microphone volume using the CH-1 fader. Make sure that the LINE 1/MIC 1-switch is set to MIC 1.
• You can connect up to 3 record players using the PHONO 1 sockets, PHONO 2 sockets and PHONO 3
sockets on the rear panel. You can only control the record player signal after you switched the PHONO /
LINE switches to PHONO. The signal is then controlled via the CH-2, CH-3 and CH-4 faders.
• Connect your tape recorder, tuner, CD-player, cassette deck or all other line signals to the LINE /AUX
sockets on the rear panel. You can only control the line signals after you switched the PHONO/LINE
switches to line. The signal is then controlled via the respective faders.
• Sound-effectors are to be connected with the EFFECTS-sockets. In this way, you can include additional
sound-effects.
• Connect the connection cable of the power-unit with the AC IN-socket. Plug the power unit into your outlet.
Balanced use with XLR connectors
2 1
1 = Ground / Shield
2 = Hot (+)
3 = Cold (-)
3
For unbalanced use pin 1 and pin 3 have to be bridged
18/41
1 2
3
Balanced use of
stereo 1/4" jack plugs
Tip =
hot (+)
Ring =
cold (-)
Sleeve =
Ground / Shield
Tip
Ring
Sleeve
Strain relief clamp
For connection of balanced and
unbalanced plugs, ring and sleeve have
to be bridged at the stereo plug.
Output
10006940_V_2_3.DOC