Brabantia 4733 Notice D'utilisation page 3

User Number
Man, Woman or athlete
indication
Body Fat Modus
Body Water Modus
Body Muscles Modus
Body Mass Index Modus
Function keys below the display
< Touch to decrease the value in the setting mode.
• Touch to confirm the value in the setting mode.
> Touch to increase the value in the setting mode.
What do you want to do?
Preparing for first use
Open the battery housing in the base of the scales and fit the batteries, making sure the + and – signs on
the batteries match the equivalent signs. Close the battery door. If the display shows 0.0 the scales are ready
for use.
Change the weighing units
You can change the measuring units from metric to imperial or vice versa (i.e. KG/ST/LB) by simply pressing
the button located on the underside of the scales.
Input personal information before use (in this example the unit kg is selected)
After confirming a step, the display will automatically show the next step. Up to 8 users can store their personal information in the scales
memory.
1. Touch • to switch on the scales – the user number (e.g. P1) will flash.
2. Touch < or > to select the desired user number and touch • to confirm.
3. Touch < or > to select the gender and/or athlete mode and touch • to confirm.
Please note: if you have a lot of exercise or train at least 5 hours a week, you can choose the athlete mode.
4. Touch < or > to select the value for your body height and touch • to confirm.
5. Touch < or > to select the value for your age and touch • to confirm.
All data will be stored automatically and you can step on the scales if 0.0 is shown on the LCD display. Data must be entered again after
battery change.
Body Height Modus
Weighing Units
Percentage Modus
Age Modus
Indication Bar
Measuring (select user manually)
1. Touch • to switch on the scales and touch < or > to select your personal user number. Wait until the LCD display shows 0.0.
2. Stand on the middle of the platform with bare feet.
3. Stand still – the weight data will be locked automatically when stable.
4. The measuring will start automatically with the indication bar moving from left to right.
5. After measuring, the results will be shown three times and then the scales will turn off automatically.
6. Put your measurements in the diary.
Measuring (select user automatically)
1. If your personal information is stored in the memory, the scales will determine your user number by the last measurement of your
weight.
2. Step onto the scales with bare feet to switch on the scales.
3. Stand still – the weight data will be locked automatically when stable.
4. If your weight is already stored in the scales memory, your user number will be selected automatically and the measurements will be
shown in cycles of three times and the scales will be turned off.
5. If there are other users of the scales whose weight data comes close to your weight, the display will show both user numbers after
calculation. You can select your user number by using < and > and touch • to confirm. If there are more users with approximately the
same weight, you have to select your personal user number manually.
LCD messages
Lo
When lo is shown, the scales will turn off after a few seconds - time to change
the batteries (4 x AAA/1.5 V).
----
Overload indication. Please remove the weight from the scales to protect the scales electronics.
ERR
Measuring error indication. The weight is shown only and the scales will turn off after a few seconds. Please step on the scales with
bare feet again and stand still until the weighing data is stored. If the problem persists, try to slightly moisten your feet.
ERR
Failed identification indication. The weight is shown only and the scales will turn off after a few seconds. Please select your Personal
Number (e.g. P1) again and measure once again.