D-Link DNS-315 Guide D'installation page 3

PrODUCT
SETUP
QUIcK InStaLLatIOn
If you have purchased a DNS-315-xTB, please skip the steps below as your device already includes
a hard drive pre-installed. Please in this case proceed directly to step 9
1. Use a screwdriver (not supplied in box) to unscrew the two screws
2. Slide the top cover away from you until it unhooks from the base
3. Unhook and open the cover from its base.
4. Keeping the DNS-315 in the upright position, insert a compatible
5. Use all six screws supplied to secure the hard drive to the base unit.
DnS-315
at the bottom of the DNS-315.
(note the direction of the D-Link logo in the image to verify the
direction).
3.5" hard drive into the drive bay of the device. (Ensure the SATA
connector is aligned with the SATA socket at the base of the unit
otherwise the DNS-315 will not power on correctly).
3