Information Messages; Figure 14: Information Messages - Astralpool HEAT B300-T Manuel Technique

ASTRALPOOLHEAT SERIES · AIR/WATER SYSTEM

5.5 Information Messages

The Information Messages appear on the screen without the need to press any key.
These messages indicate what the system is doing at any given moment.
Heat Pump
OFF
Heat Pump
External Stop
Heat Pump
No Water Flow
Defrosting
Water T. XX.XºC
Verify Temp.
In XXmXXs
Heating
Wait XXmXXs
Heating ECO
Water T. XX.XºC
THESE LAST TWO INFORMATION SCREENS ARE EQUALLY VALID WHEN THE MACHINE IS
FUNCTIONING IN COOL MODE, EXCEPT THAT INSTEAD OF "HEATING", THE DISPLAY WILL READ
Temp OK
Water T. XX.XºC
Heat Pump
Very cold air
© ASTRALPOOL 2010. ALL RIGHTS RESERVED. CONFIDENTIAL AND PROPRIETARY DOCUMENT.
The machine is stopped.
Does not heat because the user chooses not to.
The heat pump is stopped due to AUX entry.
The AUX entry can be used to program an external clock.
(see chapter 5.8.)
The water is not circulating.
The flowswitch signal indicates there is no water flow.
Defrost function is being performed.
Verify temperature.
Waiting the set time delay, countdown displayed.
Countdown for the machine to begin heating.
Complying with ventilator fan time or ON or OFF.
The machine is heating and reports the pool water
temperature.
If the machine is operating in ECO mode, this is displayed
on the screen.
"COOL".
The water temperature is as programmed by the user
(within the set margin) and indicates water temperature.
The machine is stopped because the ambient temperature
is very low.

Figure 14: Information messages.

ENGLISH
Page 37 of 246