Publicité
Les langues disponibles
Les langues disponibles
See exploded view for CSG 350/CSG 400/CDG 350/CDG 400 at the end of the do-
cument.
3. CONFORMITY OF USE
Use the device only to cook crepes, pancakes, buckwheat cakes...
4. WAY OF FUNCTIONING
This crepe machine is a strong cooktop in enamelled cast iron. The strong thickness
of the plate and its specific drawing ensure an excellent homogeneity and a stability
of the temperature. The plate's smooth surface provides direct heat transfer to the
food being cooked, without heat loss at the centre as in the periphery thanks to star-
shaped burner that covers the entire cooking surface.
To turn on and preheat the plate, just switch on the burner by pressing on the power
control knob (n°3 on picture) opposite the star position for a few seconds and on the
piezo (n°1 on picture) several times if required.
If the piezo (n°1 on picture) no longer generates the required series of sparks, you
can use a gas lighter or a long matchstick by holding it near the oblong hole (n°2 on
picture) and keeping the knob pressed (n°3 on picture) facing the star position as
indicated above.
While cooking, the temperature can be regulated using the control knob (n°3 on pic-
ture) from high flame to low flame in order to avoid over-cooking. If the crepe sticks,
it is because the crepe machine is too warm, it is then necessary to reduce the pow-
er.
A safety thermocouple cuts the gas supply if the burner is extinguished. The low
flame of the appliance is pre-adjusted in the factory, it must not be changed. This
extinction can mainly occur when there is a lot of wind. In this particular case, just
repeat the switching-on procedures described on previous page.
5. FUNCTIONING / HANDLING
a) Installation/Assembly:
- Unpack carefully the machine from its packaging.
- Place the device on a plane and heatproof surface.
- Never place the device near a wall or near a partition makes of combustible materi-
als even if it is very well isolated.
- A distance of minimum 10 cm with the partition or the wall is necessary.
b) First starting:
Before the first use, remove the anti-corrosion protection fat with a cleaner and a wet
sponge.
14
Publicité
