Hitachi Koki P 13F Mode D'emploi page 11

ASSEMBLY AND ADJUSTMENTS_Continued
Installing the Depth Adjustment Handle (Fig. 1)
1. Place the depth adjustment handle (1) on the right
hand side, on top of the machine.
2. Insert the hex socket screw into the handle. Tighten.
3. Press the cap on the left hand side.
NOTE: The depth adjustment handle can be installed on
either the right-hand side or left-hand side. The illustration
shows the crank handle on the right-hand side.
Install Power Cord Brackets (Fig. 2)
Power cord brackets (1) are provided for convenient cord
storage. Attach the power cord brackets to the back of the
tool body, as shown, with two screws (2). Tighten.
13-In. Planer
Fig. 1
1
Fig. 2
ADJUSTMENT
NOTE: This tool was accurately adjusted before shipping
from the factory. Check the following accuracy and
readjust them if necessary in order to obtain the best
results in operation.
1
2
Adjusting the Extension Table (Fig. 4, 5)
1. Pull out the cutterhead lock lever.
2. Unlock the head.
3. Turn the depth adjustment handle to raise the head.
4. Place a straight edge over the extension tables and
the main table.
5. Press down the edge against the table extensions to
remove any play.
6. If adjustment is required, fold up the extension table
and loosen the nut (1) and adjust the bolt (2) until the
tables are level.
To avoid injury from an accidental start-up, make sure the
switch is in the OFF position and the plug is not connected
to the power source.
— 11 —
Fig. 4
2
1
Fig. 5
WARNING
English