Troubleshooting; Specifications - Sony CDP-CA70ES Mode D'emploi

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
/Check that the player is connected securely.
/Make sure you operate the amplifier correctly.
/Adjust the output level using the LINE OUT
LEVEL +/– buttons on the remote.
The CD does not play.
/There's no CD inside the player ("–NO DISC–"
appears). Insert a CD.
/Place the CD with the label side up on the disc
tray correctly.
/Clean the CD (see page 20).
/Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 20).
/Place the CD in the correct position on the disc
tray.
The remote does not function.
/Remove the obstacles in the path of the remote
and the player.
/Point the remote at the remote sensor g on the
player.
/Replace all the batteries in the remote with new
ones if they are weak.
/Set the CD 1/2/3 switch on the remote
according to the position of the COMMAND
MODE selector at the rear panel of the player.
The player functions incorrectly.
/The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
Additional Information Additional Information Additional Information Additional Information

Specifications

Compact disc player
Laser Semiconductor laser (λ = 780 nm)
Emission duration: continuous
Max 44.6 µW*
Laser output
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response 2 Hz to 20 kHz ±0.3 dB
Signal-to-noise ratio More than 117 dB
Dynamic range More than 99 dB
Harmonic distortion Less than 0.0025%
Channel separation
More than 110 dB
Output
Maximum
Jack
output
type
level
LINE OUT Phono 2 V
jacks (at 50 kilohms)
DIGITAL OUT Optical –18 dBm
(OPTICAL) output
connector
PHONES Stereo 15 mW
phone jack
General
Power requirements 120 V AC, 60 Hz
Power consumption 15 W
430 × 125 × 400 mm
Dimensions (approx.)
(17 × 5 × 15 3/4 in.) incl. projecting
(w/h/d)
parts
Mass (approx.) 7.0 kg (15 lbs 7 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (1)
Size AA (R6) batteries (2)
Design and specifications are subject to change without notice.
Load
impedance
Over 10 kilohms
Wave length: 660 nm
32 ohms
21
US