ALPATEC AC 14 EIT Mode D'emploi page 20

notice_AC 14 EIT 26/02/08
- Your product can be ran either with the remote control or with the control panel.
- When you use the remote control, the picto of the different functions light on the screen.
STARTING:
- Plug the product. Open the louvers (2).
- Press touch M /A (A). The products start with the last used parameters (mode, temperature and fan
speed).
- Ambient temperature is dysplayed on the product screen.
MODE:
Use touch MODE (B) to change from one mode to another.
Each pressure modify the mode as follow:
Auto -> Cooling -> Fan
AUTO MODE:
- Temperature cannot be adjusted.
- If ambient temperature is below 23°C, the product will fan only.
- If ambient temperature is upper than 23°C, the product will switch to cooling mode.
COOLING MODE:
- If the ambient temperature is more than the desired one, the product will cool.
- If not, it will fan.
FAN ONLY MODE:
- Temperature cannot be adjusted.
- The fan is on with the selected air flow.
SET THE TEMPERATURE :
- Use touch (G) to increase or lower the desired temperature. Each pressure adds or remove 1°C.
- The selected temperature is displayed on the screen. Once the selection has been done, the ambient
temperature is displayed again.
- Temperature range is from 18°C to 32°C.
SET THE FAN SPEED:
- Use touch (C) to adjust the air flow.
- Each pressure changes the air flow as follow:
Slow -> Medium -> High
11:59 Page 20
OPERATION INSTRUCTION
20