ALPATEC AC 14 EIT Mode D'emploi page 18

notice_AC 14 EIT 26/02/08
2. THROUGH A WALL.
- Make a hole in the wall 43 cm height from the ground (center – ground) with a diameter 151 mm in order
to fixe accessory 12.
- Insert the extremity of the exhaust pipe.
When the product is not working, take out the exhaust pipe and close the hole using cap 13.
3. TEMPORARY INSTALLATION.
- Open a window or a door and put the extremity of the exhaust pipe through it.
Note: only use the provided exhaust pipe. Do not use another one or prolong it.
- It can be up to 1 m 50 long. The shorter it is, the more efficiency the unit will be.
- The pipe must not be damaged or bent..
- Avoid slopes.
MOISTURE REMOVAL.
- Your product is including the shower technology.
- However, when the humidity is very high, it may not be sufficient. Additional moistures are going in an
inner tank. When this tank is full, compressor and fan stop working and tank full indicator lights on.
- Stop the product.
11:59 Page 18
18