Hotpoint Ariston HB 0703 AB0 Mode D'emploi page 14

it en
exceed the max capacity of the cup.
3. Plug the appliance into the power outlet.
4. Lower the hand blender into the food and rotate
the speed-adjusting dial to select the desired
speed. Pressing and holding the ON/OFF
button, the blender starts blending immediately.
For maximum-speed blending use the TURBO
button for a short time.
USE THE WHISK ATTACHMENT (only
on some models) (B)
The whisk attachment is mainly suitable for whisking
egg whites.
1. To assemble the whisk attachment to the motor
unit, turn the stem clockwise until tightened.
2. Place the food into the beaker.
3. Plug the appliance into the power outlet.
4. Lower the whisk into the food and rotate the
speed-adjusting dial to select the desired speed.
Pressing and holding the ON/OFF button, the
attachment starts whisking immediately. For
maximum-speed whisking use the TURBO
button for a short time.
USE THE SMALL BOWL FOR FINE
CHOPPING (only on some models) (C)
1. First of all make sure the non-slip ring is fixed to
the bottom of the bowl.
2. Fit the knife blade on the pin in the bowl - always
fit the knife blade before adding the ingredients.
3. Cut the food into small pieces and put them into
the bowl.
A small amount of water can facilitate the
smooth running of the appliance.
Never introduce very hard foods (e.g. hard
chocolate), ice or frozen foods when using
fine chopping attachments.
4. Close with the lid.
5. Assemble the motor unit into the bowl lid and
turn it clockwise to lock them.
6. Plug the appliance into the power outlet.
7. Rotate the speed-adjusting dial to select the
desired speed. Pressing and holding the ON/
OFF button, the attachment starts chopping
immediately. For maximum speed press the
TURBO button for a short time.
8. Remove the knife blade first before pouring out
the mixture.
14
USING THE FOOD
PROCESSOR ATTACHMENT (D)
To use the chopping bowl (only on some models):
1. First of all make sure the non-slip ring is fixed to
the bottom of the bowl.
2. Fit the knife blade on the pin in the bowl - always
fit the knife blade before adding the ingredients.
3. Cut the food into small pieces and put them into
the bowl.
A small amount of water can facilitate the
smooth running of the appliance.
4. Align the two fasteners of the bowl lid with the
two clip positions of the bowl and push down to
lock them in place. Be sure to align the arrow on
the lid and the arrow on the bowl.
The fasteners must be locked in the two clip
positions, otherwise during operating the
bowl lid may rotate as the motor rotates.
Make sure the food pusher is properly fitted
into its housing on the cover.
5. Assemble the motor unit into the bowl lid and
turn it clockwise to lock them.
6. Plug the appliance into the power outlet.
7. Rotate the speed-adjusting dial to select the
desired speed. Pressing and holding the ON/
OFF button, the attachment starts chopping
immediately. For maximum speed press the
TURBO button for a short time.
8. Remove the knife blade first before pouring out
the mixture.
Using the bowl and shredding/slicing
discs for processing (only on some
models) (E).
1. First of all make sure the non-slip base is fixed to
the bottom of the bowl.
2. Then insert the disc shaft into the pin on the
bottom of the bowl, select the desired shredding/
slicing disc (fine or coarse) and assemble
the shredding /slicing disc onto the shaft with
the appropriate side upwards (one side is for
shredding, the other side is for slicing).
Extreme caution must be taken when
handling discs as they are very sharp.