Publicité
Les langues disponibles
Les langues disponibles
Operating mode switch (1), operating state LED (3), power switch (8)
Power switch ON
Operating
Subwoofer in continuous operation; the display is
mode switch
switched on.
ON
Favourable setting for the reproduction of
programmes with long quiet passages (this prevents
the subwoofer from switching off unintentionally).
Operating
The automatic switching on/off is activated
mode AUTO
(recommended setting).
If the subwoofer receives a signal from the receiver, it
turns on automatically and the display is switched on.
If the subwoofer no longer receives a signal, it will
automatically switch back to the standby mode after
approx. 20 minutes. The display is switched off the
LED turns red.
Line inputs (2)
For connecting to level outputs on a receiver/amplifier (stereo mode), see Fig. 3.
For connecting to an AV receiver with low-level subwoofer output, see Fig. 2.
Volume control (4) and remote control (11)
This control is used to set the bass volume according to your preferences. Proceed as follows:
1. The controller (4) and the – and + buttons on the remote control (11) can be used independently
of one another to adjust the volume of the subwoofer.
2. Important: Set the level control to its left stop (lowest volume).
3. Now, play back some music and set the volume control of the receiver to the desired level.
4. Set the subwoofer level control to the desired bass level.
The volume can be set between 0–40 (via the volume controller at the rear
and/or via the +/– volume buttons on the remote control).
Cross-over frequency control (5)
Used to set the upper limit of the subwoofer operating range. The cross-over frequency should be
set to 50 to 150 Hz when the system is used in combination with shelf loudspeakers or 50 to 100 Hz
when used with stand loudspeakers.
Setting range: 50 – 150 Hz.
Bass Extension control (6)
The level of the lower bass range (approx. 28 Hz) can be increased by 0 – 8 dB by using this
controller.
It is therefore easy to adapt the deep bass range to the setup of the room, as well as to your own
personal taste.
10
10
Power switch OFF
The subwoofer is
switched off, LED is
off.
This is the setting
for when subwoofer
isn't used over long
periods.
Publicité
