Mechanical Installation; Important Precautions During Installation; General Installation Guidelines - HBM S9M Notice De Montage

Masquer les pouces Voir aussi pour S9M:

Table des Matières

Les langues disponibles

Mechanical installation

• Handle the transducer with care.

• Welding currents must not be allowed to flow over the transducer. If there is

a risk that this might happen, you must use a suitable low‐ohm connection

to electrically bypass the transducer. HBM, for example, provides the highly

flexible EEK ground cable, which can be screwed on, both above and

below the transducer.

• Make sure that the transducer cannot be overloaded.

WARNING

There is a danger of the transducer breaking if it is overloaded. This can

cause danger for the operating personnel of the system in which the

transducer is installed.

Implement appropriate safety measures to avoid overloads or to protect

against resulting dangers.

The forces to be measured must act on the transducer as accurately as pos

sible in the direction of measurement. Torsional and bending moments, ec

centric loading and lateral forces may produce measurement errors and de

stroy the transducer, if limit values are exceeded.

Important

The cable fastening side of the transducer should always be connected dir

ectly with the rigid customer-side force transfer areas. Ensure that the cable

is laid so that, where possible, no force shunt is caused by the cable (e.g.

through the weight or stiffness of the cable).

HBM

S9M

A3019-5.0 en/de/fr

Table des Matières

Table des Matières