Safety Requirements; Transportation - Komfovent DOMEKT REGO 600HE-EC Manuel D'installation Et De Maintenance

SAFETY REQUIREMENTS

The air handling unit must be plugged in to an electrical outlet (with earth), which is in good order and corresponds
with all requirements of electric safety.
Before starting any operations inside the unit, make sure that the unit is switched off, and the power
cable is unplugged.

TRANSPORTATION

The air handling units are ready for transit and storage (1 Picture). The unit is packed to prevent damage of the
external and internal parts of the unit, dust and moisture penetration.
Corners of the air handling units are protected against the damage – protective corners are used. The
entire unit is wrapped up in protective film. For transit or storage, units are mounted on timber pallets. The unit is
fastened to the pallet with polypropylene packing tape over protective corners.
When unit is loaded or unloaded by crane, cargo rope is fastened in its designated places.
Forklift truck or hand pallet truck can transport air handling unit as it is shown (2 a, b, c Pictures).
UAB AMALVA we reserve the right to make changes without prior notice
• To avoid accidents and/or unit damage, only a trained technician must
carry out the connection.
• The appropriate Personal Protective Equipment (PPE) attire is worn rela-
tive to the operation being carried out.
• Electrical equipment is rated, connected and earthed in accordance with
CE regulations.
• Earth must be installed according EN61557, BS 7671.
• The unit should be installed according to Installation and Maintenance
Manual.
• Before starting the unit, check correct position of air filters.
• Service maintenance should be carried out only in conformity with the
instructions specified herein below.
• If main cable is damaged, only manufacturer, service team or trained
technician must change it in order to avoid accidents.
Vertical and horizontal units ready for transit and storage
1 Picture
13