Zanussi ZFX51400WA Notice D'utilisation page 21

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

2
1
1. Remove the plug
from the power sock-
et.
2. Remove the top
hinge cover.
3. Unscrew the 2 re-
taining screws, and
remove the hinge from
the appliance.
4. Take the door off.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cab-
inet. In that case, wait for the natural fitting of
the gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest Af-
ter Sales Service Force. The After Sales Serv-
ice specialist will carry out the reversibility of
the doors at your cost.
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate cor-
respond to your domestic power supply.
www.zanussi.com
5. Remove the screw
fixing the lower door
hinge and the other
screw fixing the lower
door hinge and the
foot. Then remove the
door hinge and the
foot as shown in the
Figure.
6. Loosen the screw
fixing the foot oppo-
site the lower door
hinge in order to re-
move the foot.
7. Fix the door hinge
and the correspond-
ing foot on the oppo-
site side and then the
other loosened foot at
the former place of
the door hinge as
shown in the Figure.
8. Please make
sure to place the
lower foot below
the door hinge. The
lower foot is recog-
nizable by its 4 ribs
on the outer sur-
face.
9. Fix the door onto
the lower hinge pin.
10. To fit top door
hinge, remove the
plastic blanking plugs
carefully, and refit
them in the holes left
by the hinge retaining
screws.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power supply
socket is not earthed, connect the appliance
to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
11. Refit the top
hinge using the 2 re-
taining screws, taking
care that the edge of
the door is parallel
with side of the cabi-
net.
12. Replace the hinge
cover.
13. Relocate the han-
dle and the plastic
plugs to the opposite
side.
14. Level the appli-
ance, wait for at least
four hours and then
connect it to the pow-
er socket.
21

Publicité

Table des Matières
loading

Table des Matières