What To Do If - Zanussi ZFX51400WA Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

4. When defrosting is completed, dry the in-
terior thoroughly.
5. Switch on the appliance.
6. Turn the Temperature Regulator to the Full
Loaded position and leave to run for at
least 4 hours.
7. Reload the previously removed food into
the compartments.
8. Adjust the Temperature Regulator accord-
ing to the quantity of the stored foods.
Warning! Never use sharp metal tools to
scrape off frost from the evaporator as
you could damage it.
Do not use a mechanical device or any
artificial means to speed up the thawing
process other than those recommended by
the manufacturer.
A temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.

What to do if...

Warning! Before troubleshooting,
disconnect the mains plug from the mains
socket.
Only a qualified electrician or competent
person must do the troubleshooting that is not
in this manual.
Important! During normal operation you may
notice that the side of the appliance is warm.
That does not mean any fault.
Problem
The appliance is noisy
The compressor operates
continually
18
Possible cause
The appliance is not supported
properly
The thermostatic control is set in-
correctly
Doors are not shut properly or do
not close tightly
The door has been opened too fre-
quently
Periods of non-operation
When the appliance is not in use for long peri-
ods, take the following precautions:
1. disconnect the appliance from electricity
supply
2. remove all food
3. defrost and clean the appliance and all
accessories
4. leave the door/doors open to prevent un-
pleasant smells.
Important! If the cabinet will be kept on, ask
somebody to check it once in a while to
prevent the food inside from spoiling in case of
a power failure.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Important! The appliance operates
discontinuously, so the stopping of
compressor does not mean being no current.
That is why you must not touch the electrical
parts of the appliance before breaking the
circuit.
Check if the appliance stands stable
(all the four feet should be on the
floor)
Adjust the Temperature Regulator
according to the quantity of the stor-
ed food
Check if the doors close well and
the gaskets are undamaged and
clean
Do not leave the door open longer
than necessary
Solution
www.zanussi.com

Publicité

Table des Matières
loading

Table des Matières