ShelterLogic ShelterCoat Round Mode D'emploi page 6

6. INSTALL TOP CROSS RAIL
A. Connect the plain end of the first cross rail (#02031) UNDER the front end rib and secure it with bolt
(#10210) as shown in Fig. 6A. HAND-TIGHTEN this bolt.
B. Connect the middle cross rails (#02030) to the first cross rail. Lay them OVER the top of the middle ribs
and connect using round head bolt (#00669). Fig. 6B.
C. The last cross rail connects UNDER the end rib with bolt #10210. Fig. 6A. HAND-TIGHTEN this bolt.
Top Cross Rail UNDER End Rib
Fig.6
10210
01010
7. SQUARING UP THE FRAME
A. Be sure that frame in its final location, which needs
to be as flat and level as possible.
B. Measure across opposite corners.
These distances must be equal to within 1 inch.
C. Check that the front and rear of the frame
measures 11 feet 6 inches in width.
8. INSTALL AUGER ANCHORS
A. Anchors must be placed inside shelter at the corner
legs. Insert a ¾-inch pipe or steel rod through the eyelet
of the auger and turn the anchor clockwise until the
eyelet is sticking out of the ground 1 to 2 inches allowing
room to be anchored to the legs.
B. Thread cable provided through the eyelet of the Anchor
as indicated in figure 9. Secure the cable with the
clamps provided.
If the ground is too hard, dig a hole with a shovel or post
hole tool. Optional: Fill with cement.
If you are anchoring in gravel, clay, or asphalt,
ShelterLogic recommends the Easy Hook
®
Anchors. Use one at each leg for a stronger, more
secure installation.
02030
02031
™ Drive
Page 6
Fig.7
11' 6"
Fig.8
Middle Rib
05_GP-BA-XXXXXXA-012XXX08_G1
Top Cross Rail OVER Middle Ribs
00669
01010
Fig.6B
11' 6"
End Rib