Staple Selection; Standard Accessories - Metabo HPT N 3804A5 Manuel D'instructions

SPECIFICATIONS
Operating pressure
Dimensions
Length × Height × Width
Weight
Magazine capacity
Air consumption

STAPLE SELECTION

● Be sure to use only the genuine metabo HPT staples for the N3804A5. The use of any other staples can
result in tool malfunction and/or staple breakdown, leading to serious injuries.
Only staples shown in the Table below can be driven with this Stapler.
Finish staples 18 gauge
ACCESSORIES
● Accessories other than those shown below can lead to malfunction and resulting injuries.

STANDARD ACCESSORIES

1
WARNING
Dimensions of staples
.138"
(3.5mm)
WARNING
3
2
70 – 120 psi (4.9 – 8.3 bar 5 – 8.5 kgf/cm
10-11/32" × 9-1/4" × 3"
(263 mm × 235 mm × 76 mm)
2.7 lbs. (1.2 kg)
100 Staples
.025 ft /cycle at 100 psi
3
(.73 ltr/cycle at 6.9 bar)
(.73 ltr/cycle at 7 kgf/cm
18 Gauge 1/4" Crown
Min.
.043"
(1.08mm)
1 Safety glasses ..........................................................1
2 Nose cap (mounted on tool) .....................................1
3 Tool Bag ...................................................................1
English
)
2
)
2
Max.
9