Methods Of Operation - Metabo HPT N 3804A5 Manuel D'instructions

If the trigger is held back, a staple will be driven each
time the push lever is pressed against the workpiece.

METHODS OF OPERATION

This Stapler is equipped with the push lever and does
not operate unless the push lever is depressed (upward
position).
There are two methods of operation to drive staples with
this Stapler.
They are:
1. Intermittent operation (Trigger fi re):
2. Continuous operation (Push lever fi re):
How to Remove the screw
• When shipped, the tool's drive mode is locked
to SINGLE
MECHANISM with the screw.
• By removing the screw as shown below, the tool
can be switched between SINGLE SEQUENTIAL
ACTUATION and CONTACT ACTUATION.
● When removing the screw, disconnect the air
hose from the tool and remove all staples.
● Please be warned that the once the screw
is removed, the SINGLE SEQUENTIAL
ACTUATION and CONTACT ACTUATION
switch function will be activated.
• Remove the screw with the screwdriver as shown
below.
CAUTION
● The screw should be discarded after removal.
(1) Intermittent operation (Trigger fi re)
Use the SINGLE SEQUENTIAL ACTUATION
MECHANISM setting.
SEQUENTIAL ACTUATION
WARNING
● For intermittent operation, set the switching
device to the upward position completely.
(i.e. Set to SINGLE SEQUENTIAL ACTUATION
MECHANISM.)
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Set the switching device to SINGLE
SEQUENTIAL ACTUATION MECHANISM.
2) Pull the trigger rapidly and fi rmly.
1 Follow the steps below to set up the SINGLE
SEQUENTIAL ACTUATION MECHANISM (as
shown in the diagrams that follow).
● Disconnect the air hose and remove all nails.
● Do not depress the push lever.
● Do not apply any unnecessary pressure or
use any tools to move the switch.
1) If the screw is left proceed from 3).
2) Set the switching device to the upward
position (to set to SINGLE SEQUENTIAL
ACTUATION MECHANISM).
(Set the switching device to the upward
position completely as shown in the diagram.
Otherwise, it will be set to CONTACT
ACTUATION MECHANISM.)
3) Make sure that the switching device is in its
proper position as shown in the diagram.
(If not, the tool may be set in the CONTACT
ACTUATION MECHANISM.)
2 Position the staple outlet on the workpiece with
fi nger off the trigger.
3 Depress the push lever fi rmly until it is completely
depressed.
4 Pull the trigger to drive a staple.
5 Remove fi nger from the trigger.
To continue stapling in a separate location, move the
stapler along the workpiece, repeating steps 2 - 5 as
required.
Switching device
English
WARNING
WARNING
1 Upward position
15